Blackridge Air Engine Cleaning Gun 750mL

Your browser's Javascript functionality is turned off. Please turn it on so that you can experience the full capabilities of this site.

Blackridge

Blackridge Air Engine Cleaning Gun 750mL

Special Offer

Item No. 572894

Qty

Add to my Wishlist

Delivery | Click & Collect | In Store

Enter your postcode to see Click & Collect, Delivery Options & In-store stock availability near you.

Enter a postcode

Time frames shown are subject to change, cut-off times are based off of AEST. See Full Shipping Terms

Product Info

Features

Large 750mL container capacity suitable for non-acidic/non-corrosive solvent of your choice
100 LPM average air consumption at 90PSI required for most efficient use
Sturdy yet lightweight alloy construction resists corrosion and solvent damage
Provides a strong targeted jet of solvent to blast away dirt and residue quickly and easily

Reviews

Rated 3 out of 5 by Michal from Works but could be better designed Does the job but you can't adjust the spray 'shape' (pointy or wide spray), you can adjust how much liquid it sprays. There's no seal or rubber o-ring in the reservoir so if you tilt it too much, the liquid pours out. I've put a rubber ring in there but still leaks if on one side as there's a big notch on the gun's thread for some reason. Another con is that you can't stand it upright when connected to an air hose as (depending on your connection I guess) my nitto fitting is lower than the base of the reservoir. Since the reservoir leaks when not vertical, it's pretty impractical and you've gotta disconnect it pretty much every time you wanna put it down.

Date published: 2021-05-21

Rated 4 out of 5 by DrShortBlock from Works well Substitute the pointlessly tiny reservoir for 3m of 5/16 fuel hose. With 4L of Mineral Turps + 90PSI it works well. Used for cleaning engine parts and block prior to blueprinting. Just don't forget the PPE!

Date published: 2020-02-23

Rated 4 out of 5 by Unclean S15 from Design could be better BUT it gets the job done Cons: - Its not easy to place on the ground due to the positioning of the compressor house inlet. - Will leak out of the top (can be fixed with DYI). Pros: - Makes cleaning freshly machined motors a breeze. Plenty of pressure to shoot right into the oil galleries and little holes. Air / Fluid mixture is adjusted with the nozzle at the top. - Excellent value for something you may use here and there to clean engine bays, motor blocks etc.

Date published: 2022-04-20

Rated 1 out of 5 by Steve. B from Endine Cleaning gun I purchased this item to degrease my engine and suspension on my 4WD. If turned more than 10 degrees to the side fluid runs out or the gun pot. A poorly executed designed at best.

Date published: 2022-01-05